Cutting and Drilling Holes in Glass

How you can Cut Holes

Various kind of glass cutters are utilized to cut the pane of a glass. If you're prepared to cut a big circle in a pane of glass, you might need a beam compass cutter or perhaps a beam circle cutter. A beam compass cutters consists of a pivot with a rubber suction pad, a cutter on the end of the beam and an adjustable beam.

1. Scoring is the initial step to cut any glass piece. So, for cutting a hole in a pane of glass, you should score the glass. Adjust the radius of the cutter and hold the pivot with its sucker in 1 hand and use the other hand to create smooth score with one continuous stroke. Now you need to score a second circle inside the very first bigger circle. Score some straight lines with this relatively smaller circle correct to the edge. Then you should score some radial lines towards the outer circle. What you should do now would be to tap the glass gently in the center of the circle on the back. This may help you drop the pieces of glass from the hole. Take breaker rack and remove the left more than pieces of the glass. Take a line glass paper wrapped around the handle of the screwdriver to smooth the edges.

2. If you're likely to cut a hole close to the edge of the pane of glass, it is better to cut the circle before cutting the size of a pane of glass.

3. It is also handy to make use of circular glass cutters for cutting the discs. Whilst using these circular glass cutters, you need to score tangential lines onto the second circle. These scored lines will help to break the pieces off from the glass. Don't forget to smooth the edges of the disc. Properly smoothed edges will give a good finish to that disc.

How to Drill Holes

A spear like unique glass bit is used to drill holes in a glass. Masonry drill ought to not be utilized in any case as it shatters the glass immediately.

1. First decide on the position with the hole on the glass. Location it on the flat surface having a good generous quantity of old newspapers. Take putty or plasticine and put it around the space chosen for a hole. Fill this with white spirit, lubricant water or paraffin.

2. You will have to be extremely careful in beginning drilling the hole at precise point. It's better to mount the drill in drill stand and start drilling slowly. Do not exert an excessive amount of pressure; proceed with slight pressure with slow speed to prevent the drill bit from overheating. When you reach at the end with the hole reduce the pressure.

3. If you are operating on mirror, it is important to drill a pinhole from the back. This will protect the silvering on the front of the mirror. After drilling a hole, you can resume your drilling job from the front.

4. For bottles, fill it with sand and rest it on the sand bed for proper support. Maintain lubricating the hole and the drill bit in between.

If you ever feel like, you'll not have the ability to do this task, do not hesitate to contact glass merchant. He will do this job for you in quite a fair price.